Showing all 4 results

Show sidebar
Close

Hungry Robot “THE MONASTERY” Polyphonic Octave Generator

$264.99
 The Monastery is a Dual Preset, Polyphonic Octave Generator that allows for simultaneous octave up and octave down with minimal latency and excellent tracking anywhere on the neck, even with multiple notes.  The Monastery is inspired by the rich, multi-layered, timbre of vintage organs with its subtle Leslie warble.    The Monastery features highly intuitive controls.  I deviated from the standard three knob "Dry,Up,Down" controls used in many octave pedals and went for a more intelligent crossfade/pan arrangement.  The biggest advantage of this setup is that the volume remains at unity-gain no matter where you set the knobs.  The left knobs are the "Dry/Wet" controls.  They adjust the ratio of wet and dry and can go from 100% wet to 100% dry with an even split at twelve o'clock.  The right knobs are the "+/-" knobs.  They work in a similar matter, but control the ratio of octave up and octave down.    The most compelling aspect of The Monastery is the dual preset function.  You can seamlessly cycle between two presets with the right footswitch.  The top LED denotes which row of controls is active.  If the LED is lit, the top row of knobs is active.  If the LED is unlit, the bottom row is active.
Close

Hungry Robot “EL CASTILLO” Arpeggiating Reverb

$294.99
El Castillo is an arpeggiating reverb that takes pitch-bent reverb to an entirely new level.   It uses a unique combination of 3 circuit blocks (reverb, pitch-shift, and delay) to create a highly experimental, ambient reverb.    REVERB – The reverb block is the heart of the pedal.  It uses the same high quality reverb brick found in my other reverb pedals.  It has two controls: “Level” and “Regen.”   The “Level” control increases the amount of wet signal, without effecting the dry signal.  The “Regen” control controls the amount of signal fed through the feedback loop.  Turing up the “Regen” knob will increase the decay and also the number or arpeggiations.     PITCH-SHIFT – The pitch-shift block is located in the feedback loop of the reverb.  Adding a pitch-shift to the feedback signal creates a “stair step” effect.  Each time the signal travels through the feedback loop, it will shift the pitch of the wet signal up or down.  The pitch shifting section is controlled by the “Quantize” mode switch and the “Pitch Knob” (small, middle knob).  More info below about the mode switch. ​ DELAY – The delay block is also located inside the feedback loop.  It is a simple, single repeat delay that can range from 0-800ms.  This feature causes the signal to delay going through the pitch-shift block.  With the delay time set at minimum, the stair stepping effect happens very quickly.  As you increase the delay time, the pitch intervals are stretched out and it creates a very gradual pitch arpeggiation.  The delay length is determined by the “Stretch” knob.   MODES - El Castillo has 2 modes of operation: Un-Quantized and Quantized.  The toggle switch selects the mode and determines the function of the “Pitch” knob.    ---In the “Un-Quantized” mode (toggle to the left), the pitch knob has a free-range and can select any pitch interval between -1 octave and +1 octave.  At 12 o’clock, there is zero pitch-shift.   ---In the “Quantized” mode (toggle to the right), the pitch-shift is locked to -1 octave and +1 Octave.  Turning the pitch knob crossfades between the two octave shifts to allow both to be heard at once or separately.  Turning the knob fully to the left provides only octave down intervals.  Turning the knob to the right provides only octave up intervals (traditional shimmer).  At 12 o’clock, there is a 50/50 blend of octave up and octave down intervals. ​